SECTION B : Opening ports from PC side ( 1. Assign an IP for your PC. )

 Go to search

Type cmd

Type ipconfig

Check the next either you are on ethernet or wifi

 



I am on ethernet, thus my info is as follow:

IPV4 192.168.1.27

Subnet mask 255.255.255.0

Default gateway 192.168.1.1

Go to Settings

Go to network and internet

Advanced network settings

Choose your network connection

RIght click then properties

Choose Internet protocol version 4 as below

 


Fill the obtained data from above as below




You can use the google DNS 8.8.8.8 and 8.8.4.4 or your provider DNS but both should be the same in PC and ROUTER.

Comments

Post a Comment

Popular posts from this blog

SECTION D: Ensure that all of your ports are open

Image
 To be sure that all of your ports are open go to the following site : 31400 to 31409 CHECKUP If after all of the previous steps, some or no ports are open then do the last effective step. Download the following program ِANALOGX Install and run. You will find the icon on the taskbar (down right) Right click than CONFIGURE The below is shown Click on Configure IP , then ADD Put the fixed IP (in my case 192.168.1.27) then choose ALLOW, OK, and DONE. As below Then click on Configure Mapping on the right side Click on ADD and start putting port 31400 on the left side and  localhost  on the right side then OK then DONE Repeat for other ports as below  To be sure that all of your ports are open go to the following site again : 31400 to 31409 CHECKUP
Read more

SECTION A : GENERAL

Image
 1. You need to have a PC or a laptop equipped with WINDOWS 10 or WINDOWS 11. 2. This PC or laptop should be VIRTUALIZATION capable. 3. For INTEL systems, use this helpful link to know your PC capability. https://www.intel.com/content/www/us/en/support/articles/000005486/processors.html 4. To check if Virtualization is enabled/disabled on your desktop/laptop, simply press Ctrl/Shift/ Esc keys to open the Task Manager. Click on the Performance tab and under CPU, you will find information about Virtualization on your desktop/laptop. 5. VIRTULIZATION should be enabled through BIOS. Check the below site for your model. https://2nwiki.2n.cz/pages/viewpage.action?pageId=75202968
Read more